News
-
14
Jun
Mean Well 1000wFeatures AGinput active surge current limitingAinput range selected by switch Protections: Short circuit / Overload / Over voltage ,Over temperature Forced air cooling by built-in DC ball bearing f...
Read More -
13
Apr
Introduction To LED DimmersDimmer is an electrical device that changes the luminous flux of the light source in the lighting device and adjusts the level of illuminance.
Read More -
08
Apr
High Efficiency Of LED DriverBattery life is critical in portable applications. If the LED driver is practical, it must be highly efficient.
Read More -
06
Apr
LED Drive DC ControlLED is a device driven by current, and its brightness is proportional to the forward current. There are two ways to control the forward current.
Read More -
03
Apr
LED Drive Requirements1. Keep constant current characteristics as much as possible, especially when the power supply voltage fluctuates by ±15%
Read More -
31
Mar
LED Driver Series Integrated Constant Power Output CircuitThe light output of the LED can be kept constant within a wide power supply range, but the efficiency of general IC circuits will therefore decrease.
Read More -
28
Mar
LED Drive Circuit BoostInductance boost and charge pump boost are two different topological modes.
Read More -
26
Mar
LED Drive Dimming MethodTraditional dimming method; PWM (Pulse Width Modulation), using simple digital pulses to repeatedly switch the LED driver. The system only needs to provide wide and narrow digital pulses to easily...
Read More -
25
Mar
LED Driver Design IdeasLED's status as a backlight source in portable products has been unshakable. Even among the backlight sources of large-size LCDs, LEDs have begun to challenge the mainstream status of CCFL (cold c...
Read More -
23
Mar
LED Drive ModeUsing a linear regulator to convert the voltage will face power consumption problems. This method is more suitable for use in conversion circuits that need to avoid noise (such as car audio) and c...
Read More -
21
Mar
LED Driver Primary Side SolutionBy completely controlling the output power and current on the AC primary side, the most accurate 5% constant current accuracy can be achieved, and the secondary side only needs a simple output cir...
Read More -
19
Mar
LED Drive Isolated Flyback CircuitUsing a flyback circuit, a DC level is generated on the secondary side through a transformer, and then the ripple of this level is fed back to the primary side through an optocoupler, thereby self...
Read More




